[ILIAS]

Выдержка из юзер мануал:

1Press the [Menu/Select] key in the control panel.
2Press the [,] key until "Banner Print OFF" is displayed.
3Press the [Menu/Select] key.
4Press the [+] or [,] key to select "ON", and then press the [Menu/Select] key.
5If the following message appears in the control panel, reposition the finisher.–If the finisher is not installed, continue with step 7.

6Place the paper to be printed on over the finisher and output tray.
7From the computer, select the job to be printed, and then click "Print" on the "File" menu.
8Specify the desired settings, and then click the [OK] button.
9Open the bypass tray.
10With the side to be printed on facing down, insert the paper as much as possible into the feed slot.–Before loading the paper, check that the following message appears in the control panel:
Set Paper BP:LP TH1
11 Slide the lateral guides to fit the size of paper being loaded.–Load only one sheet of paper at a time.–Print while supporting the loaded paper with your hands.
12 Press the [Menu/Select] key.Printing begins.–The end of the printed paper will be fed into the top of the finisher.–To continue printing, repeat steps 10 through 12.
13 When printing is finished, press the [Cancel] key.
BANNER PRINTING

14Press the [Menu/Select] key.–If the finisher is installed, return it to its original position.

OK to exit
Banner mode?